Concentric Slave Cylinder Fittings

Orient is your trust hydraulic throwout bearing supplier in China which has made two efforts to ensure strict quality control. A complete dynamic recording mechanism for supplier quality has been established based on raw material evaluation. After confirming that the quality of raw materials provided by suppliers meets the requirements, raw materials can be accepted for storage, ensuring product quality stability from the source. Simultaneously, all produced bearings are subjected to a 100 percent comprehensive inspection before shipment, and only the inspection data can be sent to customers if they meet the requirements of the drawings. As a result, quality will not be an issue for you from the moment you call Orient with your order.

Concentric Slave Cylinder Fittings

A slave cylinder fitting that is concentric is a crucial component of a hydraulic clutch system. If your vehicle’s clutch system is hydraulic, you must attach a hydraulic hose to the cylinder. The rapid attach method is inefficient and necessitates a hydraulic pipe connection. Fortunately, options exist. Here are few.

Difficulties with concentric slave cylinder connections
Ensure the slave cylinder is disconnected from the hydraulic hose prior to disassembling it. Then unscrew it with the shoulder towards the housing of the clutch. Next, ensure that the pushrod is sideways and clear of the release lever. A wooden wedge can also be used to hold the cylinder in place. Then, forcefully push the cylinder out.

Concentric Slave Cylinder Fittings
The replacement tube should be linked to the hydraulic pipe via the slave cylinder’s fluid port. When removing the new hydraulic tube, be cautious not to damage the body of the slave cylinder. It is essential to route the new hydraulic tube in the same manner as the previous one.

Concentric Slave Cylinder Fittings

Hydraulic pipe connection size
It is essential to choose the suitable hydraulic pipe connection size for concentric slave cyl fittings. A larger slave cyl will have the same effect as a smaller slave cyl, but it will have greater pedal pressure and release travel at the thrust bearing. A big m/cyl will result in increased pedal pressure, but may also increase mechanical friction in the system.

Ensure you purchase slave cylinders with both male and female fittings. Typically, the female fitting is smaller than the male fitting. The male OD connection is incompatible with the female slave cylinder. In addition, you must ensure that the hose and pipe connections are of the correct size.

Concentric Slave Cylinder Fittings

In addition to the size of the hydraulic pipe connection, the fittings must be able to support the hose size.

Concentric Slave Cylinder Fittings
emplacement of the hydraulic pipe connection
To ensure that the hydraulic pipe connection for concentric slave cylinders is centered, check that the cylinder’s bellhousing connection is flush and tight. Do not overtighten the screws, as this could cause the guide sleeve to separate from the bell housing and the seal to separate.Concentric Slave Cylinder Fittings.

Apply extra sealant to the cylinder if necessary.